Got the new boat! And a bit of an engineering problem.

[nokatchin]

Nice rig,congrats

[RonE]

Great looking boat, how are you going to be able to stand it?

[WestEndAngler]

Nice boat Sandy!

[Explorer21]

NICE RIG SANDY!!! Can't wait to see it at the camp.

[coachlaw]

I dont care who you take it to but if you bring it to me i can section it and weld it back together. then i'll get it powder coated white to match the hull.

Dat's why I asked for your opinion specifically Bro. After seeing what you did with that rod rack you made for the camp, it's obvious you know what you're doin'.

PM me an estimate if you will. If I can cover it presently, I'll bring it out to you on Tuesday if that works for ya. I have teacher in-service that day, so I'll be outta here at 3pm instead of the regular 4pm. I'll get with you later this week.

[Robalo]

Nice Sandy. My Skeeter has a fold down grab rail and removable windshield-the grab rail change should be pretty easy. I bet you can get some release wing type nuts for the windshield and just undo them to remove windshield. The grabrail has plastic screwknobs so easy to loosen and lower. Next time I'm aground, err, I mean around your camp I can show you how it's set up.

[2112]

Take measurements. Remove. Push under carport. Give grab rail to TXSHOCKWAVE.
You're good to go!
Hey man, it's cool seeing you with a newish rig. It could'nt had happened to a better person.

[Mell Wader]

Nice Sandy! You will have fun with that rig.

[TXSHOCKWAVE]

I dont care who you take it to but if you bring it to me i can section it and weld it back together. then i'll get it powder coated white to match the hull.

[imhammer]

Congrats Sandy....Nice clean rig!

[Williep]

[quote=Primer;52529]I wonder if you could lower the trailer jack and push it under the port?[/quote]



I was going to ask the same question.




.

[JimD]

I had the same problem with the BC so I had Donny put me a grab rail that will fold down and the windshield is the same one they use on their smaller boats and it has the 6 plastic screws that I can take off in 30 seconds pull two pins and fold the grab rail over forwards to fit in the garage.

Think it cost was 120 extra. Just got to remember to lower it before putting the boat in the garage.

I had thought about lowering the set up but then lower 6-8 inches is too much of the windshield to lose when I laid it out unless you are 5 ft tall.
Need a px of what it looks like let me know.

[Nwilkins]

Sweet Rig, congrats Sandy

[bountyhunter]

Yep...Jason could fix that right up....or.....you could just keep that thing at my house.

Naw you got a boat at your house, he can leave his boat at my house and his truck at your house........

Congrats Sandy!!!!!!!!

Good luck fixing your little problem. Hunting season is now over so I'm ready to get back into fishing. Ready to yak out to the camp again when the weather is good........

[007]

Call Millenium Marine...Mike knows them well Sandy. He can work wonders!
Like the boat bud...very clean!

Yep...Jason could fix that right up....or.....you could just keep that thing at my house.